INTEMPCO LTX01 series 2-wire level transmitters are
highly reliable microprocessor based sensors designed to measure
tank levels of liquids and certain dry bulk media in metal tanks.
LTX01 sensors measure the change in capacitance that occurs as the
tank level changes and outputs a standard loop-powered 4-20mA
signal. After calibration any change in level is recognized and
converted to an analog 4-20mA signal. LTX01 sensors use very high
frequency and very low amplitude sensing circuitry to greatly
minimize the effects of coating on the sensing probe.
The
LTX01 includes a standard 4 - 20mA loop powered LTX transmitter
housed in a rugged enclosure, a 0.50-inch diameter rigid probe for
ranges up to 20 feet and a fitting. Probe material is SS316,
supplied bare or PFA jacketed. The LTX01 is designed for tanks which
have fitting connections of 3/4 NPT or larger.
LTX01 can be
used in many tough industrial applications. This level sensor is
shock resistant and very rugged. There are no moving parts. PFA
jacketed probe can withstand temperatures of up to 200°C and
pressures to 500 psi.
|
 |
 |
- Continuous
loop powered 4-20 mA operation
- Microprocessor
Based
- Accuracy
1% of span for constant dielectric of material
- Non-interactive
zero and span calibration
- Calibration
accomplished with 4 push buttons
- Heavy
duty industrial design
- NEMA
rated aluminum, stainless, PVC and explosion proof housings
available
- Standard
fitting 3/4 NPT, flange and special fittings
available
|
 |
- Water
and water-based liquids
- Jacketed
probes required for conductive media
- Organic
Acids
- Oils
and fuels in some metalic tanks
- Use
bare probes with non-conductive media
- Use
cable probes where top side access is limited
- On-site
calibration required
- Not
recommended where material dielectric changes
- Tank
must be conductive or grounding may be required or see other
Intempco level
probe
| |
